On-Site Surface Preparation Equipment Service

Sometimes the machine cannot leave the jobsite. Legacy Industrial Solutions provides on-site service and technical support in the local area around Santa Fe Springs, with clear limits on what we can do outside and what must come back to the shop.

One Shop, Not a National Field Fleet

Legacy is one repair shop in Santa Fe Springs. We do not claim a network of field service centers or a van in every state. On-site work happens in the local area and depends on the machine and the scope.

If a job needs a full teardown, machining, or bench equipment, we will tell you plainly and bring the machine to the shop.

Jobs That Suit On-Site Service

On-site service makes sense when the problem is accessible, the repair is contained, and moving the machine is harder than fixing it where it sits.

Diagnosis and Troubleshooting

Electrical faults, VFD codes, hydraulic symptoms, propane engine running issues, and controls problems can often be diagnosed on site before the machine is moved.

Adjustment and Calibration

Blast wheel adjustment, scarifier drum depth setup, belt tension, tracking, and control calibration. Work that does not require a full teardown or specialized bench tooling.

Smaller Repairs

Hose replacement, electrical repairs, switch replacement, control repairs, minor hydraulic work, and some filter and wear-part changes that can be done safely in the field.

PM Visits

Preventive maintenance inspections at your yard, rental branch, or jobsite. We inspect, document, and replace consumables on the spot when the work is field-friendly.

Technical Support and Start-Up Help

Start-up checks on a newly acquired machine, control familiarization, operator training, or a worksite demonstration of machine use. Sometimes the right hour on site prevents a week of downtime.

When a Machine Must Come to the Shop

Some repairs are honest shop work. We will say so upfront rather than waste a trip.

  • Major teardowns. Planetary gearbox rebuilds, complete engine work, or full hydraulic system overhauls need a clean bench and the full tooling we keep at the shop.
  • Machining and fabrication. Shaft repair, weld repair, custom bracket fabrication, and precision work require equipment we do not bring to the field.
  • Work needing the test bench. Load testing on 230V or 480V power, propane leak-down checks with fixed equipment, and dust collector airflow verification are better done under controlled conditions.
  • Jobs that need a hoist or press. If the repair involves heavy lifting, pressing bearings, or splitting a large assembly, the shop is the right place.
Blastrac shot blasting machines set up for a rooftop concrete preparation job

Where On-Site Service Happens

On-site work is concentrated in the local area around Santa Fe Springs, including Los Angeles, Orange County, the Inland Empire, and nearby industrial corridors. Travel beyond that depends on the scope and the number of machines.

Out-of-area customers should use nationwide freight to ship the machine to the shop. It is usually faster and less expensive than sending a single technician across the country.

Santa Fe Springs
Los Angeles County
Orange County
Inland Empire
Longer travel by scope and machine count

What to Tell Us When You Call

The more we know, the faster we can decide whether the job belongs on site or at the shop.

  • Machine make, model, and serial number if available
  • Symptom or fault code, and when it started
  • Jobsite or yard address, and access restrictions
  • Power or fuel available on site
  • Whether the machine can be moved or must stay put
  • Your timeline and how the machine fits into it

Not a National Field Fleet, and Proud of It

We are not going to pretend there is a service van in every metro area. What we offer is an honest scope: on-site work when it makes sense, shop repair when it does not, and clear communication either way.

If you are outside Southern California, the fastest path to a working machine is usually shipping it to the shop. We can coordinate freight both directions.

ON-SITE OR IN-SHOP, THE PROMISE IS THE SAME

Call to Discuss Your Machine

Describe the machine, the fault, and the location. We will tell you honestly whether the job fits on-site service or whether the bench will get you back to work faster.